Settings Menu

The Settings menu gives you control over how your project is set up and displayed. It’s where you can adjust system preferences, measurement settings, and customise the way information is shown in the field.

To access it, go to the Home menu and tap Settings.

What you can do in this menu

• System Information

  
  Check your software version, active modules, and licence details. You can also change the display language.

• Display Settings

  
  Customise how your screen looks in measure mode, design view, and map layers. Adjust viewing direction and choose which panels are visible.

  You can also access this directly from the main map screen.

• eBubble Settings

  
  Calibrate the eBubble and adjust sensitivity and tolerance levels (available on IMU-enabled receivers such as SPS986 and R780).

• Measurement Modes

  
  Switch between different modes depending on how you’re working:

  • Standing
  • Walking
  • Vehicle
  • Static
  • EZ Level

• Information Display

  
  Choose what data appears in the information bar and panels to suit your workflow.

• Measurement Settings

  
  Fine-tune how measurements are taken, including:

  • Default point input (name or code)
  • Offsets
  • Tolerance limits (above/below)

• Stakeout Settings

  
  Configure how stakeout is performed, including:

  • Horizontal tolerance
  • Marking method
  • Stake length
  • Cut/fill intervals
  • Station mode (fixed or random)

• Corridor Stakeout Settings (Roading module required)

  
  Set preferences for road and corridor work, such as:

  • Station intervals
  • Auto-advance
  • Tangent points
  • Subgrade offsets
  • Guidelines and display options

• Surface Settings

  
  Adjust surface offsets and choose:

  • Offset type (vertical or perpendicular)
  • Offset direction (above or below)

• Secondary Surface Settings

  
  Configure how a second surface is used and displayed in your project.

• Reference Line Setup

  
  Select and manage reference lines used in your workflows.

• Avoidance Zones

  
  Set tolerance limits for any exclusion or avoidance zones loaded into the project.

• Catch Point Settings

  
  Configure how catch points are staked and measured.

• Total Station Settings (when connected)

  
  Adjust:

  • Scale factor
  • Atmospheric corrections
  • Radio settings
  • Raw data output

• Total Station Calibration

  
  Run compensator and collimation adjustments to maintain accuracy.

• Units Display

  
  Choose how units are shown (primarily for projects using feet):

  • Decimal feet
  • Decimal inches
  • Fractional inches

• PDF Report Branding

  
  Add your company logo and header details to exported PDF reports for a professional finish.